Electromagnetic

First-Time-Right Antennas for Wireless Product Teams

Independent analysis by Starro. Not client work.

A square copper patch antenna on a circuit board with blue waves radiating from it

Objective

Covering the 5.8 GHz Band on Every Board

Every wireless product needs an antenna tuned to its band. Printed patches are narrowband, so laminate permittivity, thickness and etched length decide whether a board lands on frequency or needs a respin.

Which laminate and feed give a 5.8 GHz patch antenna that covers its band on every board, not just the nominal one?

Findings

Permittivity Tolerance Decides Yield

On 0.813 mm RO4003C the −10 dB bandwidth is 94 MHz, too narrow for the 125 MHz band. At 1.524 mm it is 150 MHz with 93 % efficiency; FR-4 at 1.6 mm reaches 198 MHz but only 65 % efficiency.

Permittivity dominates the tolerances: a 0.1 change moves the resonance about 77 MHz, against about 10 MHz for 25 µm of etch. With the feed tuned to spread the match across the band, coverage rises from 33 % to 66 % of boards on 1.524 mm RO4003C and to 100 % at 2.0 mm, against 37 % for 1.524 mm FR-4.

Radiation efficiency against laminate thickness, and share of simulated boards covering the band for two feed placements.

Approach

Cavity Model With Monte Carlo Production Tolerances

Probe-fed rectangular patches for the 5.725 to 5.850 GHz band, modeled with the cavity and transmission-line models, including slot conductance, conductor, dielectric and radiation quality factors and probe reactance. Production yield is estimated by Monte Carlo sampling of permittivity, thickness and etch tolerances.

Probe-fed rectangular patch in top and side view; the patch length sets resonance and the probe position sets input resistance.

Validation

Textbook Example and Independent Radiation Q

How we checked the model:

  • A textbook design example (Balanis, Antenna Theory) is reproduced to three significant figures.

  • Radiation Q matches the independent closed form of Jackson and Alexopoulos within 2 %: 24.3 against 24.7 on 1.524 mm RO4003C.

  • Slot conductance matches its narrow-slot asymptote within 0.03 %.

  • Radiated power computed two ways agrees within 6 %.

Recommendations

Choose the Laminate and Feed Before Layout

Choose the laminate for its permittivity tolerance and thickness before the layout, and place the feed to spread the match across the band rather than peak it at the center. Thicker low-loss laminate covers the band on every board in this model; FR-4 loses 1.8 dB of gain to dielectric loss and misses the band on most boards.

Tools used:

Cavity and transmission-line patch models; Monte Carlo production yield