Structural
Lighter, Proven Wing Spars for UAV Structures Teams
Independent analysis by Starro. Not client work.

Objective
Spar Mass for a Small UAV Wing
Small UAV wing spars are often off-the-shelf tubes of constant diameter, sized by habit. A spar that follows the load can save most of its mass, but only if the loads and the proof test are credible.
How much spar mass does a small UAV need, and what sets it: material, depth or stiffness?
Findings
Section Depth Matters More Than Material
The root bending moment at the 4 g limit is 311 N·m. A constant 25 mm aluminum tube weighs 3.46 kg and a constant carbon tube 0.97 kg. Following the airfoil depth cuts the carbon spar to 0.31 kg, 68 % less, and a tapered aluminum tube (0.90 kg) still beats the constant carbon one.
For light designs, stiffness and minimum gauge, not strength, set the mass. A four-point whiffletree per wing half reproduces the design bending moment within 1 % of its root value, which gives a simple, credible proof test.

Approach
Lifting-Line Loads to Spar Sizing and Proof Test
A 25 kg, 3.6 m tapered wing taken from lifting-line loads, solved by Glauert's method and scaled to a 4 g limit with a 1.5 factor of safety, to spar sizing and a static test rig. Circular aluminum and carbon spars are sized for strength, local buckling and a tip deflection limit of 10 % of semi-span.

Validation
Exact Elliptic-Wing and Beam Solutions
How we checked the model:
Elliptic-wing lift matches the exact solution: lift coefficient 0.47388 against 0.47388, span efficiency 1.0000.
The lift series converges: the spanwise centroid moves 0.9 % from 40 to 320 terms.
Beam integration matches the closed-form cantilever deflection.
Root shear equals half the net lift: 431.5 N.
Recommendations
Taper the Spar Before Paying for Carbon
Section depth matters more than material: taper the spar with the airfoil before paying for carbon. Size for deflection and minimum gauge as well as strength, and plan the proof test with the design; a four-point rig per half loads the spar as it will fly.
Tools used:
Lifting-line loads (Glauert); beam sizing for strength, buckling and deflection; static test rig design


